+ Reply to Thread
Results 1 to 4 of 4

Thread: 2010 Class Rules

  1. Join Date
    Dec 2008
    Posts
    34

    2010 Class Rules

    Downloadable Version here:
    http://camasvalleyfundays.com/forums...classrules.doc



    Technical Obstacle Course
    Class Definition



    Stock Class
    This class is designed for vehicles with no more than three modifications.

    Class limitations and requirements:
    Ø Vehicles limited to 35”or smaller tires.
    Ø Bead locks are not allowed in this class.
    Ø Dual transfer case or non-factory gear reduction at transmission/transfer case, not allowed.
    Ø Must have original axle type or available axle for the same year and style of vehicle.
    Ø Must have original engine configuration (number of cylinders) or available option for the same year and style of the vehicle. Forced induction (e.g. turbocharger, supercharger), not allowed unless originally equipped from factory. Must run on pump gas.
    Ø Must have original suspension configuration (e.g. leaf springs, radius arm and coil, etc.). A solid front axle conversion will be considered a modification, but will not solely exclude vehicle from class.
    Ø Must have full body on full length of frame. If pickup, must have original length bed. Tube doors or competing minus doors are acceptable. A “comp” cutting fender for clearance is also acceptable. As long as vehicle retains original factory “look”. Fenders, hood and bed (or tub) must be full factory width.
    Modified Class
    Class for vehicles with four or more modifications.

    Class limitations and requirements:
    Ø Vehicle limited to 38.5” or smaller tires.
    Ø Bead locks are allowed
    Ø Any engine acceptable
    Ø Must have original suspension configuration (e.g. leaf spring, radius arm and coil, etc.). A solid front axle conversion is acceptable.
    Ø Must be a body on original frame build, and resemble original vehicle. Must have seating for at least two. Cab or tub must be full width from cowl to behind front seats, must have hood over engine compartment.”Dovenose”, “dovetail”, are acceptable. Flat or shortened beds, also acceptable.
    Ø Any axle that is not “portal” design, planetary gear design, or rated for more than one and half tons, is acceptable.

    Unlimited Class
    ANYTHING GOES- Tube chassis, rock buggy, tractor tired mud boggers. Any rig that does not conform to the stock or modified class rules will compete in this class.

  2. Join Date
    Dec 2008
    Posts
    34

    Open Flat Track


    Team Relay
    Ø All vehicles required to pass standard tech inspection and required as well to have minimum of single loop roll bar securely attached.
    Ø Any intentional contact will be immediate dis-qualification.
    Ø Each team will start at one of four colored gates and each gate will have a starter flagger. Second team vehicle can only leave after the previous vehicle has fully through the return gate.
    Ø There will be a main tower with a flag tech who will put out one of three flags (green, yellow, red, and black), so be aware of the flag posted. If you are flagged off the track please be respectful, they may see something that you don’t.
    Ø Trophy for the winning team.

    Barrel Races
    Ø All vehicles required to pass standard tech inspection and required as well to have minimum of single loop roll bar securely attached.
    Ø There will be three barrels in a triangular pattern that are 100 feet apart.
    Ø You can go any direction around the barrels as long as you go completely around each one.
    Ø You have two chances for best time and the lowest time is kept.
    Ø You can make your two runs anytime until the deadline.
    Ø If you knock over a barrel, that run adds a 5 sec. penalty for each barrel.
    Ø If you do not stop in the gate one axle your run will be dis-qualified.

    Wheel to Wheel
    Ø All vehicles must have roll cage and door bars and comply with tech qualifications.
    Ø Tech Officials have the right to refuse vehicle for wheel to wheel on their discretion
    Ø Anything else goes!!!!!!!

  3. Join Date
    Dec 2008
    Posts
    34

    Dirt Drags


    Four Wheel Drive Dirt Drags
    Ø Track is 100 yards with 100 yards of slow down.
    Ø Starter will use traditional flag start.
    Ø Finish line will have blue strobe for win lane.
    Ø Races are a double elimination(must loose twice).
    Ø After your race you will be directed to restage in win lane or loose lane.
    Ø There are no ties, laser finish is good to 1/16 of an inch.
    Ø You can race in more than one class and bump up a class if you qualify.
    Ø Must pass Tech Qualifications.
    Ø Tech Officials have the right to refuse vehicle for wheel to wheel on their discretion.
    Ø Classes:
    v 4-6 Cyl. Stock--4-6 Cyl. Modified
    v 4x4 Stock Truck—4x4 Modified Truck
    v Jeep, Bronco, Scout Stock-- Jeep, Bronco, Scout Modified
    v Ladies class
    v Open Class
    v X Class
    v Open unlimited ( anything goes, even two wheel drive, sand rails, etc)
    ATV DRAGS
    Ø Track is 100 yards with 100 yards of slow down.
    Ø Starter will stage and race will be started with green srrobes
    Ø Finish line will have blue strobe for win lane.
    Ø Races are a double elimination(must loose twice).
    Ø After your race you will be directed to restage in win lane or loose lane.
    Ø There are no ties, laser finish is good to 1/16 of an inch.
    Ø You can race in more than one class and bump up a class if you qualify.
    Ø Must pass Tech Qualifications.
    Ø Tech Officials have the right to refuse vehicle for wheel to wheel on their discretion.
    Ø Youth racers below the age of 18 must have legal guardian sign release of liability.
    Ø Classes:
    v Pee Wee 0-80cc
    v Junior 81-150cc
    v Intermediate 151-230cc
    v Bikes 0-125cc
    v Utility ATV
    v 2 Stroke 200-500cc
    v 4 Stroke 0-400cc
    v 4 Stroke 401-900 cc
    v Open Class
    v X Class

  4. Join Date
    Jan 2009
    Location
    Rogue River, South of GP
    Posts
    40

    I like it! Good Job!

    See you guys in June.
    The mud pit doesn't like me...

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts